The IKON IBB49-2G-24SS Back Bar Cooler
The IKON IBB49-2G-24SS is a two-section back bar cooler with 10.45 cubic feet of refrigerated storage behind two hinged glass swing doors and a full stainless steel exterior. Where the standard IBB49-2G-24 uses black paint, this model wraps the entire cabinet in stainless steel for a brighter, more polished look that suits upscale bar environments, open kitchens, or front-of-house installations where the cooler is visible to guests. Inside, 288 twelve-ounce cans or 216 twelve-ounce bottles stay between 33 and 40 degrees Fahrenheit. Magnetic door gaskets are replaceable without tools.
Lockable Glass Doors with Heavy-Duty Epoxy-Coated Wire Shelves
Each glass door comes with a lock and key, so you can secure the cabinet after hours or limit access during events. Behind each door, two adjustable heavy-duty epoxy-coated wire shelves let you set the spacing to fit everything from tall bottles on the bottom to six-packs stacked on top. The epoxy coating resists corrosion from the moisture and condensation inside a refrigerated cabinet, so the shelves hold up through years of daily loading and unloading rather than rusting out the way bare wire shelves would. You can reconfigure the shelf heights in minutes to switch between bottle-heavy and can-heavy layouts as your inventory mix changes.
Left-Mounted R290 Compressor with Stainless Steel Interior
The compressor mounts on the left side of the cabinet where it draws cooler ambient air and keeps the mechanical components accessible for service without pulling the unit away from the wall. R290 refrigerant paired with foam insulation holds the interior between 33 and 40 degrees Fahrenheit. The electronic thermostat and digital LED temperature display are readable at a glance from behind the bar, and you can adjust the setpoint without opening the doors. The interior walls are 430 stainless steel with a 304 stainless steel floor, giving you a corrosion-resistant surface that wipes clean after spills. The top is 430 stainless steel, so you can use it as a service surface for garnish trays, glassware, or speed rails. Four-inch casters with two lockable casters in front let you roll the unit out for cleaning and lock it back into position. Power runs on 115V/60/1 with a NEMA 5-15P plug and a 10-foot cord.
The IBB49-2G-24SS measures 49.1 inches wide by 24.4 inches deep by 41.7 inches high. The 0.40 HP compressor draws 3 amps on 115V/60/1 power.
About IKON
IKON is a commercial refrigeration line built for foodservice operations that balance back-of-house prep with front-of-house visibility. The range covers reach-ins, glass door merchandisers, prep tables, undercounters, and bar units, giving operators flexibility across kitchen and service areas. Units are constructed with stainless steel and use R290 refrigerant, with digital temperature controls that are easy to read and adjust during service. Bottom-mounted refrigeration is common across the line, which helps in hotter kitchen environments and simplifies routine cleaning. IKON is often used in restaurants, convenience stores, and bars that need consistent performance across mixed refrigeration formats.
Features & Benefits
-
Back bar cooler with lockable glass doors for refrigerated beverage storage behind the bar
-
Two-section, 10.45 cu. ft. capacity
-
(2) Hinged Glass Swing Doors, lockable with key
-
(4) Adjustable Shelves (2 per door), heavy-duty epoxy-coated wire
-
Holds (288) 12 oz. cans or (216) 12 oz. bottles
-
Temperature Range: 33-40°F (0.5-4°C)
-
Electronic thermostat with digital LED temperature display
-
R290 refrigerant with foam insulation
-
Left-side mounted self-contained compressor, 0.40 HP, 3A
-
Door Gaskets: Magnetic, tool-free replaceable
-
Top: 430 stainless steel
-
Interior: 430 stainless steel with 304 stainless steel floor
-
Exterior: Stainless steel
-
(4) 4" casters, (2) lockable in front
-
Exterior Dimensions (W x D x H): 49.1" x 24.4" x 41.7"
-
115V/60/1, NEMA 5-15P, 10 ft cord
Free Shipping 48 Contiguous states & DC only.
In Stock: Ships in 1-2 Business Days
Back bar cooler with lockable glass doors for refrigerated beverage storage behind the bar
Two-section, 10.45 cu. ft. capacity
(2) Hinged Glass Swing Doors, lockable with key
(4) Adjustable Shelves (2 per door), heavy-duty epoxy-coated wire
Holds (288) 12 oz. cans or (216) 12 oz. bottles
The IKON IBB49-2G-24SS Back Bar Cooler
The IKON IBB49-2G-24SS is a two-section back bar cooler with 10.45 cubic feet of refrigerated storage behind two hinged glass swing doors and a full stainless steel exterior. Where the standard IBB49-2G-24 uses black paint, this model wraps the entire cabinet in stainless steel for a brighter, more polished look that suits upscale bar environments, open kitchens, or front-of-house installations where the cooler is visible to guests. Inside, 288 twelve-ounce cans or 216 twelve-ounce bottles stay between 33 and 40 degrees Fahrenheit. Magnetic door gaskets are replaceable without tools.
Lockable Glass Doors with Heavy-Duty Epoxy-Coated Wire Shelves
Each glass door comes with a lock and key, so you can secure the cabinet after hours or limit access during events. Behind each door, two adjustable heavy-duty epoxy-coated wire shelves let you set the spacing to fit everything from tall bottles on the bottom to six-packs stacked on top. The epoxy coating resists corrosion from the moisture and condensation inside a refrigerated cabinet, so the shelves hold up through years of daily loading and unloading rather than rusting out the way bare wire shelves would. You can reconfigure the shelf heights in minutes to switch between bottle-heavy and can-heavy layouts as your inventory mix changes.
Left-Mounted R290 Compressor with Stainless Steel Interior
The compressor mounts on the left side of the cabinet where it draws cooler ambient air and keeps the mechanical components accessible for service without pulling the unit away from the wall. R290 refrigerant paired with foam insulation holds the interior between 33 and 40 degrees Fahrenheit. The electronic thermostat and digital LED temperature display are readable at a glance from behind the bar, and you can adjust the setpoint without opening the doors. The interior walls are 430 stainless steel with a 304 stainless steel floor, giving you a corrosion-resistant surface that wipes clean after spills. The top is 430 stainless steel, so you can use it as a service surface for garnish trays, glassware, or speed rails. Four-inch casters with two lockable casters in front let you roll the unit out for cleaning and lock it back into position. Power runs on 115V/60/1 with a NEMA 5-15P plug and a 10-foot cord.
The IBB49-2G-24SS measures 49.1 inches wide by 24.4 inches deep by 41.7 inches high. The 0.40 HP compressor draws 3 amps on 115V/60/1 power.
About IKON
IKON is a commercial refrigeration line built for foodservice operations that balance back-of-house prep with front-of-house visibility. The range covers reach-ins, glass door merchandisers, prep tables, undercounters, and bar units, giving operators flexibility across kitchen and service areas. Units are constructed with stainless steel and use R290 refrigerant, with digital temperature controls that are easy to read and adjust during service. Bottom-mounted refrigeration is common across the line, which helps in hotter kitchen environments and simplifies routine cleaning. IKON is often used in restaurants, convenience stores, and bars that need consistent performance across mixed refrigeration formats.
Features & Benefits
-
Back bar cooler with lockable glass doors for refrigerated beverage storage behind the bar
-
Two-section, 10.45 cu. ft. capacity
-
(2) Hinged Glass Swing Doors, lockable with key
-
(4) Adjustable Shelves (2 per door), heavy-duty epoxy-coated wire
-
Holds (288) 12 oz. cans or (216) 12 oz. bottles
-
Temperature Range: 33-40°F (0.5-4°C)
-
Electronic thermostat with digital LED temperature display
-
R290 refrigerant with foam insulation
-
Left-side mounted self-contained compressor, 0.40 HP, 3A
-
Door Gaskets: Magnetic, tool-free replaceable
-
Top: 430 stainless steel
-
Interior: 430 stainless steel with 304 stainless steel floor
-
Exterior: Stainless steel
-
(4) 4" casters, (2) lockable in front
-
Exterior Dimensions (W x D x H): 49.1" x 24.4" x 41.7"
-
115V/60/1, NEMA 5-15P, 10 ft cord
Resources & Downloads
See all from IKON
Specifications
| Overall Dimensions (W x D x H) | 49.1" x 24.4" x 41.7" |
| Capacity | 10.45 cu. ft. |
| Sections | Two-section |
| Can Storage | (288) 12 oz. Cans |
| Bottle Storage | (216) 12 oz. Bottles |
| Temperature Range | 33-40°F (0.5-4°C) |
| Doors | (2) Hinged Glass Swing Doors |
| Door Lock | Lock and Key |
| Door Gaskets | Magnetic, tool-free replaceable |
| Shelves | (4) Adjustable Shelves (2 per door), Epoxy-Coated Wire |
| Refrigerant | R290 |
| Compressor Size | 0.40 HP |
| Compressor Location | Left-Side Mounted, Self-Contained |
| Rated Current | 3A |
| Insulation | Foam |
| Top Surface | 430 Stainless Steel |
| Interior | 430 Stainless Steel with 304 Stainless Steel Floor |
| Exterior | Stainless Steel |
| Casters | (4) 4" Casters, (2) Lockable in Front |
| Voltage | 115V/60/1 |
| NEMA Plug | 5-15P |
| Cord Length | 10 ft |
Manufacturer's Warranty
-
2 Year
Labor
-
2 Year
Parts
-
3 Year
Compressor (Parts Only)
Certifications & Approvals
-
ETL Sanitation
Back bar cooler with lockable glass doors for refrigerated beverage storage behind the bar