IKON IBB61-2G-24SS 61 In. Two-section Back Bar Cooler, Swing Glass Doors, Stainless Steel Exterior, R290

The IKON IBB61-2G-24SS is a two-section back bar cooler with 14.16 cubic feet of refrigerated storage behind two hinged glass swing doors and a full stainless steel exterior. The 61-inch width holds 432 twelve-ounce cans or 324 twelve-ounce bottles. The stainless steel finish gives the cabinet a clean, professional appearance that works well in visible bar settings, event spaces, and open-concept restaurants where painted black cabinets would look out of place. Magnetic door gaskets snap in and out without tools for quick replacement.

Lockable Glass Doors with Heavy-Duty Epoxy-Coated Wire Shelves

Each glass door comes with a lock and key, so you can secure the cabinet after hours or limit access during events. Behind each door, two adjustable heavy-duty epoxy-coated wire shelves let you set the spacing to fit everything from tall bottles on the bottom to six-packs stacked on top. The epoxy coating resists corrosion from the moisture and condensation inside a refrigerated cabinet, so the shelves hold up through years of daily loading and unloading rather than rusting out the way bare wire shelves would. You can reconfigure the shelf heights in minutes to switch between bottle-heavy and can-heavy layouts as your inventory mix changes.

Left-Mounted R290 Compressor with Stainless Steel Interior

The compressor mounts on the left side of the cabinet where it draws cooler ambient air and keeps the mechanical components accessible for service without pulling the unit away from the wall. R290 refrigerant paired with foam insulation holds the interior between 33 and 40 degrees Fahrenheit. The electronic thermostat and digital LED temperature display are readable at a glance from behind the bar, and you can adjust the setpoint without opening the doors. The interior walls are 430 stainless steel with a 304 stainless steel floor, giving you a corrosion-resistant surface that wipes clean after spills. The top is 430 stainless steel, so you can use it as a service surface for garnish trays, glassware, or speed rails. Four-inch casters with two lockable casters in front let you roll the unit out for cleaning and lock it back into position. Power runs on 115V/60/1 with a NEMA 5-15P plug and a 10-foot cord.

The IBB61-2G-24SS measures 61.1 inches wide by 24.4 inches deep by 41.7 inches high. The 0.40 HP compressor draws 3 amps on 115V/60/1 power.