The Comstock-Castle 10201 Gas Griddle
The Comstock-Castle 10201 is a 30 inch wide countertop gas griddle and hotplate combination from the 10 Series, built in Quincy, Illinois for diners, food trucks and small lines that need a flat top and a couple of open burners in one 30 inch footprint. A 20 inch manual griddle section runs on 2 burners and a 10 inch hotplate section carries 2 open burners for stock pots and saute pans. All 4 burners are cast iron H pattern rated at 12,000 BTU, 48,000 BTU total, and the unit ships set up for natural gas or propane as you specify.
On a short line this replaces two pieces of equipment. Eggs and hash browns run on the griddle while a pan of gravy or a pot of grits sits on an open burner next to it, with one gas connection and one footprint on the counter.
20 Inch Griddle With 1/2 Inch Polished Steel Plate
The griddle plate is 1/2 inch highly polished steel, 20 inches wide by 16 inches deep for 320 square inches of cooking surface. A 2 inch stainless splash guard wraps the back and sides, and a front cold zone grease trough with a large drain slot feeds a seamless, large capacity grease drawer. If you run heavier product, 3/4 inch and 1 inch plates and chrome plating are factory options.
2 Open Burners at 12,000 BTU Each
The hotplate section gives you 2 cast iron H pattern burners at 12,000 BTU apiece. That is enough for a 20 quart stock pot held at a simmer or a saute pan brought up to heat between griddle batches, without tying up griddle space with a pot.
Manual Brass Gas Valves With Standing Pilots
Every burner has its own brass gas valve with an automatic standing pilot, so the griddle and each open burner are set by hand. Nothing to calibrate and nothing to fail but a valve. The 10T201 is the same unit with thermostatic control on the griddle. Pressure regulators are factory set for the gas you order, 4 inch WC natural gas or 10 inch WC propane, on a 3/4 inch NPT manifold.
Welded Stainless Steel Frame, 10 Inches High
The body is corrosion resistant stainless steel on a welded frame with an aluminized steel back panel, 22.5 inches deep and 10 inches high so it sits low on a counter or equipment stand. Clearance to non-combustible surfaces is zero at the sides and rear; to combustible surfaces it is 6 inches on the sides and 6 inches at the rear. The 10 Series is built to match up with Comstock-Castle Economy charbroilers and hotplates.
About Comstock-Castle
Founded in 1838 in Quincy, Illinois, Comstock-Castle is America's oldest stove manufacturer still in operation. The company grew from a frontier hardware shop into a grey-iron foundry that helped make Quincy the nation's stove-production hub by the early 1900s. Seven generations later, Comstock-Castle still designs and union-builds commercial cooking equipment in the same Quincy facility, with ranges, griddles, charbroilers, fryers, and modular cook lines configurable from 24 to 72 inches to match your menu. Built to outlast the kitchens that put them on the line.
Features & Benefits
-
30 inch countertop gas griddle and hotplate combination, natural gas or propane (specify at order)
-
20 inch manual griddle section on 2 burners plus 2 open burners
-
4 cast iron H pattern burners at 12,000 BTU each, 48,000 BTU total
-
1/2 inch highly polished steel griddle plate, 20 x 16 inch cooking surface (320 sq. in.)
-
3/4 inch and 1 inch plates and chrome plating available
-
Manual control on griddle and open burners
-
Brass gas valves with automatic standing pilots
-
Factory set pressure regulator: 4 inch WC natural gas, 10 inch WC propane; 3/4 inch NPT manifold
-
2 inch stainless steel splash guard, optional high sides
-
Front cold zone grease trough with large drain slot and seamless large capacity grease drawer
-
Welded stainless steel frame with aluminized steel back panel, 22.5 inches deep, 10 inches high
-
Zero clearance to non-combustible surfaces; 6 inches to combustible surfaces at sides and rear
-
Matches up with Comstock-Castle Economy charbroilers and hotplates
-
Options: legs, grill scrapers, spatulas, safety pilot controls, gas hoses, carrying handles, knob protectors, matching equipment stands
-
Made in Quincy, Illinois
Free Shipping 48 Contiguous states & DC only.
In Stock: Ships in 1-2 Business Days
30 inch countertop gas griddle and hotplate combination, natural gas or propane (specify at order)
20 inch manual griddle section on 2 burners plus 2 open burners
4 cast iron H pattern burners at 12,000 BTU each, 48,000 BTU total
1/2 inch highly polished steel griddle plate, 20 x 16 inch cooking surface (320 sq. in.)
3/4 inch and 1 inch plates and chrome plating available
The Comstock-Castle 10201 Gas Griddle
The Comstock-Castle 10201 is a 30 inch wide countertop gas griddle and hotplate combination from the 10 Series, built in Quincy, Illinois for diners, food trucks and small lines that need a flat top and a couple of open burners in one 30 inch footprint. A 20 inch manual griddle section runs on 2 burners and a 10 inch hotplate section carries 2 open burners for stock pots and saute pans. All 4 burners are cast iron H pattern rated at 12,000 BTU, 48,000 BTU total, and the unit ships set up for natural gas or propane as you specify.
On a short line this replaces two pieces of equipment. Eggs and hash browns run on the griddle while a pan of gravy or a pot of grits sits on an open burner next to it, with one gas connection and one footprint on the counter.
20 Inch Griddle With 1/2 Inch Polished Steel Plate
The griddle plate is 1/2 inch highly polished steel, 20 inches wide by 16 inches deep for 320 square inches of cooking surface. A 2 inch stainless splash guard wraps the back and sides, and a front cold zone grease trough with a large drain slot feeds a seamless, large capacity grease drawer. If you run heavier product, 3/4 inch and 1 inch plates and chrome plating are factory options.
2 Open Burners at 12,000 BTU Each
The hotplate section gives you 2 cast iron H pattern burners at 12,000 BTU apiece. That is enough for a 20 quart stock pot held at a simmer or a saute pan brought up to heat between griddle batches, without tying up griddle space with a pot.
Manual Brass Gas Valves With Standing Pilots
Every burner has its own brass gas valve with an automatic standing pilot, so the griddle and each open burner are set by hand. Nothing to calibrate and nothing to fail but a valve. The 10T201 is the same unit with thermostatic control on the griddle. Pressure regulators are factory set for the gas you order, 4 inch WC natural gas or 10 inch WC propane, on a 3/4 inch NPT manifold.
Welded Stainless Steel Frame, 10 Inches High
The body is corrosion resistant stainless steel on a welded frame with an aluminized steel back panel, 22.5 inches deep and 10 inches high so it sits low on a counter or equipment stand. Clearance to non-combustible surfaces is zero at the sides and rear; to combustible surfaces it is 6 inches on the sides and 6 inches at the rear. The 10 Series is built to match up with Comstock-Castle Economy charbroilers and hotplates.
About Comstock-Castle
Founded in 1838 in Quincy, Illinois, Comstock-Castle is America's oldest stove manufacturer still in operation. The company grew from a frontier hardware shop into a grey-iron foundry that helped make Quincy the nation's stove-production hub by the early 1900s. Seven generations later, Comstock-Castle still designs and union-builds commercial cooking equipment in the same Quincy facility, with ranges, griddles, charbroilers, fryers, and modular cook lines configurable from 24 to 72 inches to match your menu. Built to outlast the kitchens that put them on the line.
Features & Benefits
-
30 inch countertop gas griddle and hotplate combination, natural gas or propane (specify at order)
-
20 inch manual griddle section on 2 burners plus 2 open burners
-
4 cast iron H pattern burners at 12,000 BTU each, 48,000 BTU total
-
1/2 inch highly polished steel griddle plate, 20 x 16 inch cooking surface (320 sq. in.)
-
3/4 inch and 1 inch plates and chrome plating available
-
Manual control on griddle and open burners
-
Brass gas valves with automatic standing pilots
-
Factory set pressure regulator: 4 inch WC natural gas, 10 inch WC propane; 3/4 inch NPT manifold
-
2 inch stainless steel splash guard, optional high sides
-
Front cold zone grease trough with large drain slot and seamless large capacity grease drawer
-
Welded stainless steel frame with aluminized steel back panel, 22.5 inches deep, 10 inches high
-
Zero clearance to non-combustible surfaces; 6 inches to combustible surfaces at sides and rear
-
Matches up with Comstock-Castle Economy charbroilers and hotplates
-
Options: legs, grill scrapers, spatulas, safety pilot controls, gas hoses, carrying handles, knob protectors, matching equipment stands
-
Made in Quincy, Illinois
Resources & Downloads
See all from Comstock-Castle
Specifications
| Width | 30" |
| Depth | 22.5" |
| Height | 10" |
| Griddle Width | 20" |
| Cooking Surface Depth | 16" |
| Griddle Cooking Surface | 320 sq. in. |
| Hotplate Width | 10" |
| Number of Griddle Burners | 2 |
| Number of Open Burners | 2 |
| Total Burners | 4 |
| Burner Rating | 12,000 BTU each |
| Total BTU | 48,000 |
| Burner Type | Cast iron H pattern |
| Control Type | Manual |
| Gas Type | Natural Gas or Propane, specify at order |
| Gas Pressure (Natural) | 4" WC |
| Gas Pressure (Propane) | 10" WC |
| Gas Connection | 3/4" NPT |
| Ignition | Automatic standing pilot |
| Griddle Plate Thickness | 1/2" |
| Griddle Plate Material | Polished steel |
| Splash Guard | 2" stainless steel |
| Grease Trough | Front cold zone with drain to removable drawer |
| Exterior Finish | Stainless steel |
| Back Panel | Aluminized steel |
| Clearance, Non-Combustible | 0" sides, 0" rear |
| Clearance, Combustible | 6" sides, 6" rear |
| Net Weight (approx.) | 125 lbs |
| Country of Origin | USA |
Manufacturer's Warranty
-
1 Year
Labor
-
1 Year
Parts
Certifications & Approvals
-
NSF Approved
-
ETL US & Canada
-
Made in USA
30 inch countertop gas griddle and hotplate combination, natural gas or propane (specify at order)