The Mecnosud PK44ADUS Spiral Dough Mixer
The Mecnosud PK44ADUS is a two-speed spiral dough mixer with a removable stainless steel bowl and a lifting head, built for pizza shops, bakeries, and restaurant prep lines that mix dough in batches of up to 97 lb (44 kg) at 55 percent hydration. That is roughly 170 pizza dough balls at 9 oz each from one bowl, or enough bread and focaccia dough to carry a small bakery through the morning, from a machine 33.46" wide. It is not sized for a wholesale plant turning out several hundred pounds an hour, but unlike the fixed-bowl PK models it lets you lift the head, pull the full bowl off the base, and carry it to the bench or the sink. It runs on 220 V three-phase 60 Hz power, arrives wired without a plug for your electrician to connect, and rolls on casters with brakes so you can pull it out for cleaning and lock it back in place.
Removable Bowl and Lifting Head
The head tilts up and the bowl lifts off the base, which changes how the mixer fits into a busy kitchen. When a batch finishes you can lift the whole bowl of dough to the bench for dividing instead of scooping it out a handful at a time, and the base is free for the next batch. At close, the bowl goes to the sink for a full wash rather than a wipe-down in place, which Mecnosud lists as one of the advantages of the removable design. The lifting head also opens up the spiral and the shaft for cleaning. Plan the station with room above the mixer to swing the head up.
Two Speeds for Flour Pickup and Gluten Development
The spiral turns at 120 rpm in first speed and 240 rpm in second, and the bowl follows at 15 and 30 rpm, so the hook and the bowl stay in the same ratio at either setting. Run first speed while the flour takes up the water and the mass is still shaggy, then switch to second to build gluten once the dough has come together. A planetary mixer with a dough hook works the dough from one side of the bowl; here the bowl rotation carries the dough into the spiral from every angle, so a stiff pizza dough gets kneaded evenly without climbing the hook or riding the bowl wall. Two fixed speeds also keep training simple for a prep crew that rotates through the station.
Stainless Steel Bowl, Spiral, and Shaft
The bowl holds 55 qt (50 L, 13.2 gal), measures 19.68" (50 cm) across and 10.6" (27 cm) deep, and is rated for 66 lb (30 kg) of flour per batch, which works out to the 97 lb dough figure at 55 percent hydration. Wetter doughs take up more volume, so a high-hydration ciabatta batch should be sized smaller than a pizza batch. The bowl, the spiral, and the shaft that drives it are all stainless steel, so the surfaces that touch dough wipe down with a damp cloth between a sweet dough and a savory one instead of needing a scrub, and they do not pit from salt or acidic preferments.
Geared Motor With Double-Chain Drive
A 3 HP geared motor turns the spiral and the bowl through a double-chain drive. Chain drive holds its ratio under load, so the spiral does not slow down when a low-hydration bagel dough tightens up the way a belt can slip, and the gearing takes the torque so the motor runs at its rated speed instead of lugging. The motor draws 6.7 A on 220 V three-phase 60 Hz, which means a dedicated three-phase circuit rather than a wall outlet; the unit is supplied wired with no plug. Mecnosud notes that the PK models are the evolution of its IM line.
Mechanical Panel With Timer and Emergency Stop
Controls are a mechanical panel on the head: selector switches for speed, a timer dial, a green start button, and a red emergency stop. There is no touchscreen or recipe memory, which is the point for a pizzeria where the same dough gets made every day. Set the timer for the knead, press start, and go portion the last batch while the mixer finishes and shuts itself off. The emergency stop is a red button you can hit with a flour-covered palm, and the dial timer means a new hire can run the machine after a five-minute walkthrough.
Stainless Steel Guard and Painted Steel Frame on Braked Casters
A stainless steel wire guard covers the bowl during the cycle, keeping hands away from the turning spiral while you can still see how the dough is coming together. The frame is thick steel coated in a non-toxic paint, which is what keeps a mixer this heavy from walking across the floor at second speed. Casters with brakes are standard: unlock them to pull the mixer out and mop behind it, then lock them before the next batch so the machine stays put against a full bowl of stiff dough.
About Mecnosud
Mecnosud is an Italian manufacturer with over four decades of expertise in dough-processing machinery tailored for artisan bakeries, pizzerias, and pastry operations. The brand emphasizes engineering precision and stainless-steel reliability, offering spiral and fork mixers, sheeters, dividers, dough rollers, and proofing equipment built entirely in Italy. Its product line supports full-scale dough preparation, from mixing to forming, delivering consistent performance across varied production environments. Mecnosud’s support network and industrial craftsmanship have earned global respect among institutions and chain-scale operations worldwide}.
Features & Benefits
-
Pizza, bread, and focaccia dough mixing for pizza shops, bakeries, and restaurant prep lines
-
Removable bowl that lifts off the base so a full batch goes to the bench or the sink
-
Lifting head that tilts up to free the bowl and expose the spiral for cleaning
-
Two spiral speeds, 120 and 240 rpm, for flour pickup first and gluten development second
-
Bowl rotation at 15 and 30 rpm that feeds dough into the spiral from every side
-
Stainless steel bowl, spiral, and shaft that wipe clean between sweet and savory doughs
-
Geared motor with a double-chain drive that holds spiral speed under a stiff dough load
-
Mechanical control panel with speed selectors, a dial timer, and a red emergency stop
-
Dial timer that ends the cycle on its own while you portion the previous batch
-
Stainless steel wire guard over the bowl that keeps hands clear of the turning spiral
-
Thick steel frame with a non-toxic paint coating that resists walking at second speed
-
Casters with brakes so the mixer rolls out for cleaning and locks in place for mixing
-
Three-phase motor supplied wired without a plug for a dedicated circuit
-
Capacity rated at 55 percent hydration, so wetter doughs should be batched smaller
Free Shipping 48 Contiguous states & DC only.
In Stock: Ships in 1-2 Business Days
The Mecnosud PK44ADUS Spiral Dough Mixer
The Mecnosud PK44ADUS is a two-speed spiral dough mixer with a removable stainless steel bowl and a lifting head, built for pizza shops, bakeries, and restaurant prep lines that mix dough in batches of up to 97 lb (44 kg) at 55 percent hydration. That is roughly 170 pizza dough balls at 9 oz each from one bowl, or enough bread and focaccia dough to carry a small bakery through the morning, from a machine 33.46" wide. It is not sized for a wholesale plant turning out several hundred pounds an hour, but unlike the fixed-bowl PK models it lets you lift the head, pull the full bowl off the base, and carry it to the bench or the sink. It runs on 220 V three-phase 60 Hz power, arrives wired without a plug for your electrician to connect, and rolls on casters with brakes so you can pull it out for cleaning and lock it back in place.
Removable Bowl and Lifting Head
The head tilts up and the bowl lifts off the base, which changes how the mixer fits into a busy kitchen. When a batch finishes you can lift the whole bowl of dough to the bench for dividing instead of scooping it out a handful at a time, and the base is free for the next batch. At close, the bowl goes to the sink for a full wash rather than a wipe-down in place, which Mecnosud lists as one of the advantages of the removable design. The lifting head also opens up the spiral and the shaft for cleaning. Plan the station with room above the mixer to swing the head up.
Two Speeds for Flour Pickup and Gluten Development
The spiral turns at 120 rpm in first speed and 240 rpm in second, and the bowl follows at 15 and 30 rpm, so the hook and the bowl stay in the same ratio at either setting. Run first speed while the flour takes up the water and the mass is still shaggy, then switch to second to build gluten once the dough has come together. A planetary mixer with a dough hook works the dough from one side of the bowl; here the bowl rotation carries the dough into the spiral from every angle, so a stiff pizza dough gets kneaded evenly without climbing the hook or riding the bowl wall. Two fixed speeds also keep training simple for a prep crew that rotates through the station.
Stainless Steel Bowl, Spiral, and Shaft
The bowl holds 55 qt (50 L, 13.2 gal), measures 19.68" (50 cm) across and 10.6" (27 cm) deep, and is rated for 66 lb (30 kg) of flour per batch, which works out to the 97 lb dough figure at 55 percent hydration. Wetter doughs take up more volume, so a high-hydration ciabatta batch should be sized smaller than a pizza batch. The bowl, the spiral, and the shaft that drives it are all stainless steel, so the surfaces that touch dough wipe down with a damp cloth between a sweet dough and a savory one instead of needing a scrub, and they do not pit from salt or acidic preferments.
Geared Motor With Double-Chain Drive
A 3 HP geared motor turns the spiral and the bowl through a double-chain drive. Chain drive holds its ratio under load, so the spiral does not slow down when a low-hydration bagel dough tightens up the way a belt can slip, and the gearing takes the torque so the motor runs at its rated speed instead of lugging. The motor draws 6.7 A on 220 V three-phase 60 Hz, which means a dedicated three-phase circuit rather than a wall outlet; the unit is supplied wired with no plug. Mecnosud notes that the PK models are the evolution of its IM line.
Mechanical Panel With Timer and Emergency Stop
Controls are a mechanical panel on the head: selector switches for speed, a timer dial, a green start button, and a red emergency stop. There is no touchscreen or recipe memory, which is the point for a pizzeria where the same dough gets made every day. Set the timer for the knead, press start, and go portion the last batch while the mixer finishes and shuts itself off. The emergency stop is a red button you can hit with a flour-covered palm, and the dial timer means a new hire can run the machine after a five-minute walkthrough.
Stainless Steel Guard and Painted Steel Frame on Braked Casters
A stainless steel wire guard covers the bowl during the cycle, keeping hands away from the turning spiral while you can still see how the dough is coming together. The frame is thick steel coated in a non-toxic paint, which is what keeps a mixer this heavy from walking across the floor at second speed. Casters with brakes are standard: unlock them to pull the mixer out and mop behind it, then lock them before the next batch so the machine stays put against a full bowl of stiff dough.
About Mecnosud
Mecnosud is an Italian manufacturer with over four decades of expertise in dough-processing machinery tailored for artisan bakeries, pizzerias, and pastry operations. The brand emphasizes engineering precision and stainless-steel reliability, offering spiral and fork mixers, sheeters, dividers, dough rollers, and proofing equipment built entirely in Italy. Its product line supports full-scale dough preparation, from mixing to forming, delivering consistent performance across varied production environments. Mecnosud’s support network and industrial craftsmanship have earned global respect among institutions and chain-scale operations worldwide}.
Features & Benefits
-
Pizza, bread, and focaccia dough mixing for pizza shops, bakeries, and restaurant prep lines
-
Removable bowl that lifts off the base so a full batch goes to the bench or the sink
-
Lifting head that tilts up to free the bowl and expose the spiral for cleaning
-
Two spiral speeds, 120 and 240 rpm, for flour pickup first and gluten development second
-
Bowl rotation at 15 and 30 rpm that feeds dough into the spiral from every side
-
Stainless steel bowl, spiral, and shaft that wipe clean between sweet and savory doughs
-
Geared motor with a double-chain drive that holds spiral speed under a stiff dough load
-
Mechanical control panel with speed selectors, a dial timer, and a red emergency stop
-
Dial timer that ends the cycle on its own while you portion the previous batch
-
Stainless steel wire guard over the bowl that keeps hands clear of the turning spiral
-
Thick steel frame with a non-toxic paint coating that resists walking at second speed
-
Casters with brakes so the mixer rolls out for cleaning and locks in place for mixing
-
Three-phase motor supplied wired without a plug for a dedicated circuit
-
Capacity rated at 55 percent hydration, so wetter doughs should be batched smaller
Resources & Downloads
See all from Mecnosud
Specifications
| Dough Capacity | 97 lb (44 kg) |
| Flour Capacity | 66 lb (30 kg) |
| Capacity Basis | 55% hydration |
| Bowl Volume | 55 qt (50 L, 13.2 gal) |
| Bowl Material | Stainless steel |
| Bowl Type | Removable |
| Head | Lifting |
| Bowl Internal Diameter | 19.68" (50 cm) |
| Bowl Internal Height | 10.6" (27 cm) |
| Spiral Material | Stainless steel |
| Shaft Material | Stainless steel |
| Speeds | 2 |
| Spiral RPM | 120 / 240 |
| Bowl RPM | 15 / 30 |
| Drive System | Geared motor, double-chain drive |
| Motor Power | 3 HP |
| Voltage / Phase / Hz | 220 V / 3 Ph / 60 Hz |
| Amperage | 6.7 A |
| Plug | Wired, no plug |
| Controls | Mechanical, selectors, start, emergency stop |
| Timer | Included |
| Safety Guard | Stainless steel wire guard on head |
| Frame Construction | Thick steel, non-toxic paint |
| Casters | Included, with brakes |
| Overall Dimensions W x D x H | 33.46" x 20.86" x 30.31" (85 x 53 x 77 cm) |
| Shipping Weight | 309 lb (140 kg) |
| Country of Origin | Italy |
Manufacturer's Warranty
-
1 Year
Labor
-
1 Year
Parts
Certifications & Approvals
-
NSF Approved
-
ETL US & Canada
-
ETL Sanitation
-
Made in Italy

